by Elizabeth Miller | May 16, 2024 | Article, Fabrication, Machining
Pictured are sand separator bottoms fabricated at Miller from Duplex 2205 stainless steel that will be sent to a pulp and paper facility in Texas. These are ASME code vessels with surface cladding on the flange as well as an internal ring that is machined here at...
by Elizabeth Miller | Mar 15, 2024 | Article, Fabrication, Machining, Waterjet
Seen in the photos are the last stages of the manufacturing of our latest scarfing machine. This machine is approximately 22 Ft. in height and 29 ft. in width and weighs about 96,000 pounds. Its composition is thousands of pieces of machined and fabricated parts, 90%...
by Elizabeth Miller | Feb 27, 2024 | Article, Fabrication
Pictured is our latest 1,800-gallon ASME flash tank in process and ready for shipping to our friends in Skowhegan, Maine. This particular vessel was made with ½ inch carbon steel with stainless steel nozzles. It has two internal chambers with internal piping. It was...
by Elizabeth Miller | Feb 5, 2024 | Article, Fabrication, Machining, Waterjet
The Miller Industrial Manufacturing team is currently working on the construction of our latest scarfing machine for L-Tec. This scarfing machine will be completed using four of the divisions of Miller. It has been fabricated, machined, has pieces cut via our...
by Elizabeth Miller | Aug 24, 2023 | Article, Fabrication, Machining, Waterjet
This continuous digester top replacement was fabricated at our Glens Falls, NY facility. The replacement shell was fabricated in three sections, to facilitate trucking to the pulp and paper mill site in Georgia, then field assembled, onsite, into one piece and lifted...
