Blog
Helpful and industry-relavent articles written by Miller Industrial Manufacturing
Sand Separator Bottoms
Pictured are sand separator bottoms fabricated at Miller from Duplex 2205 stainless steel that will be sent to a pulp and paper facility in Texas. These are ASME code vessels with surface cladding on the flange as well as an internal ring that is machined here at Miller…
The Latest Scarfing Machine
Seen in the photos are the last stages of the manufacturing of our latest scarfing machine. This machine is approximately 22 Ft. in height and 29 ft. in width and weighs about 96,000 pounds. Its composition is thousands of pieces of machined and fabricated …
Fabulous Fabricators
Pictured is our latest 1,800-gallon ASME flash tank in process and ready for shipping to our friends in Skowhegan, Maine.
This particular vessel was made with ½ inch carbon steel with stainless steel…
Processes at Waterjet
The Miller Waterjet Dept. is currently working on a large production order for a pharmaceutical and medical device company. This process starts with cutting precision blanks with our 87k PSI Flow Waterjets
Our Latest Scarfing Machine in Process
The Miller Industrial Manufacturing team is currently working on the construction of our latest scarfing machine for L-Tec. This scarfing machine will be completed using four of the divisions of Miller. It has been fabricated, machined, has pieces cut via our...
Debarker Dilemma
The crew from Miller discovered the gear box was fine while the shaft needed repair. The shaft was removed with the help of a 100-ton hydraulic jack and was consequently sent out to manufacturer to determine the cause of failure…
Latest Steaming Vessel
The horizontal steaming vessel in the Kamyr feed system has an internal screw that carries the chips through and preheats the chips and drives off the air and other noncondensibles. This is an important factor in maintaining column movement in the digester. Pictured...
Continuous Digester Top
This continuous digester top replacement was fabricated at our Glens Falls, NY facility. The replacement shell was fabricated in three sections, to facilitate trucking to the pulp and paper mill site in Georgia, then field assembled, onsite, into one piece and lifted...
From Field Services to Manufacturing Through Waterjets
""Miller Industrial Manufacturing (formerly Miller Mechanical Services), began as a field services group for the pulp and paper industry. Over the past 30 years, they've diversified to provide engineering solutions, metal fabrication and machining, and pulp and paper...
The Latest in Dryer Can Refurbishing
Pictured are paper machine dryer sections that dry and remove the water by way of a series of internally steam-heated cylinders that evaporate the moisture from the paper web. Below are the dryer cans refurbished by Miller by grinding the outside via the lather,...